Raspberry Pi is a delicate card computer. This starter kit of Raspberry Pi is very suitable for zero-based raspberry pi enthusiasts. Through this kit, you can learn more about the Linux operating system and C language programming based on the Debian system of Raspberry Pi.

This kit also provides you with some related sensors and modules applied to the Raspberry Pi. We offer richer learning materials that allow you to learn about Raspberry Pi from scratch. The learning materials include the installation and usage of the Raspberry Pi related system, where also offer you the learning courses of Raspberry Pi collocated with some commonly used sensors and modules.

It would be better If you are an Arduino hobbyist because Arduino and Raspberry Pi are the best partners. You can make more creative DIY works via Arduino strong community support and rich third-party library resources, integrating into Raspberry Pi’s powerful function support to motivate your creativity and inspiration!.

*This kit does not include Raspberry Pi board

The Raspberry Pi is a low cost, credit-card sized computer. It can be taken as a personal server and router. You could get a camera monitor by plugging camber to it, equally, the voice interactive function could be achieved if microphone and speaker are connected with Raspberry Pi. Raspberry Pi extends 40 Pins to link with sensors and modules, which contributes to make all kinds of  experiments. This kit is produced for Raspberry Pi enthusiasts. You could acquire the knowledge of Linux, Python and other  programming, as well as the application of sensors/ modules.

Kit Includes:

• 5 x LED Blue
• 5 x LED Red
• 5 x LED Yellow
• 8 x 220Ω Resistor
• 5 x 10KΩ Resistor
• 5 x 1KΩ Resistor
• 1 x Passive Buzzer
• 1 x Active Buzzer
• 1 x Ball Tilt Sensor
• 3 x Photoresistor
• 1 x Flame Sensor
• 1 x 74HC595N Chip
• 1 x 1 Digit 7
• 1 x segment LED Display
• 1 x 4 Digit 7
• 1 x segment LED Display
• 1 x 5V Stepper Motor
• 1 x Stepper Driver
• 1 x Servo Motor
• 1 x Joystick Module
• 1 x Relay Module
• 1 x Access Key
• 1 x RFID Card
• 1 x GPIO PCF8591 Shield
• 1 x 10KΩ Potentiometer
• 1 x 8*8 LED Dot Matrix
• 1 x 1602 LCD Display
• 1 x IR Remote Control
• 1 x IR Receiver Sensor
• 4 x Large Button Switch
• 1 x LM35DZ Temperature Sensor
• 1 x PIR Motion Sensor
• 1 x MQ-2 Analog Gas Sensor
• 1 x ADXL345 Three Axis Acceleration Module
• 1 x HC-SR04 Ultrasonic Sensor
• 1 x DS3231 Clock Module
• 1 x DHT11 Temperature and Humidity Sensor
• 1 x Soil Humidity Sensor – 1 x RFID-RC522 Module
• 1 x RPI GPIO Shield
• 40 pin Colourful Jumper Wires
• 1 x 830-Hole Breadboard
• 40 Pin Headers
• 20 Female to Female Dupont Wires
• 20 Male to Female Dupont Wires
• 30 Jumper Wire

*This kit does not include Raspberry Pi board

Documents

• Ultimate Starter Kit for Raspberry Pi 3 – Complete User Guide
• Ultimate Starter Kit for Raspberry Pi 3 – Tutorials