The module has a popular L298N controller, which controls the direction and speed of two DC motors. Thanks to ARK screw connectors, the power supply and motors themselves can be easily connected by screwing wires with a screwdriver. Control signals are connected to popular gold pin connectors, allowing the circuit to be connected to run boards, such as Arduino, using wires.
PINOUTS
| Pin | Description |
|---|---|
| VMS | Supply voltage for motors from 5 V to 46 V. |
| 5V | Power supply of the logic part after the stabilizer – active after removing the 5V jumper. |
| GND | System ground |
| MOTOR A |
Motor A channel outputs. |
| MOTOR B |
Outputs of motor channel B. |
| ENA | PWM signal for speed control of motor A. |
| IN1, IN2 | Direction control of motor channel A |
| ENB | PWM signal for motor speed control B. |
| IN3, IN4 | Direction control of channel B |
| IN1 / IN3 | IN2 / IN4 | Motor outputs |
|---|---|---|
| status high |
status low state |
The motor turns clockwise at the maximum speed set by PWM (different from 0). |
| state low state |
state high |
The motor turns at the maximum speed set via pwm (different from 0) counterclockwise. |
| state low |
state low state |
When the high state is given to the PWM input – the motor is braked quickly (fast stop). |
| state high state |
state
high state |
When the high state is given to the PWM input – fast motor braking (fast stop). |
| state high |
state high state |
When the low state is given to the PWM input – free braking (soft stop). |
SPECIFICATION
- Supply voltage: from 5 V to 46 V
- Supply voltage of the logic part: 5 V
- Built-in 5 V voltage regulator for the logic part with the possibility to disconnect it using a jumper
- Maximum output current: 2 A per channel
- The module allows control of two DC motors or one stepper motor
- Motor outputs and power inputs are connected to ARK screw terminals
- Input pins of the logic part are available on gold pin connectors – 2,54 mm pitch
- On the board, there are all the necessary passive elements for the proper operation of the controller
- The circuit has a radiator-mounted
- Board dimensions are: 60 x 55 x 30 mm
SHIPPING LIST
- 1x L298N 1A DC Motor Driver Controller Board
There are no reviews yet.